Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / maharaja
1.IR VALUE SHOULD BE MORE THAN 3MEGA OHMS FOR 1KV
2.PI VALUE SHOULD BE MORE THAN 1.4
3.TAN DELTA VALUE SHOULD BE LESS THAN .07%
4.ALL TRIPING AND INTER TRIPING SHOULD BE CHECKED.
5.AFTER CHARGING WE HAVE TO CHECK THE NOISE.
6.AFTER CHARGING WE HAVE TO CHECK THE WINDING AND OIL
TEMPERATURE 4 EACH ONE HOUR INTERVAL.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
What is meant by turbo alternators?
wheather the size of windings in motor and generator are the same
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
how we can set the IDMT relay.
How to test IR testing & magnetic balance test
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
single phase power supply give to separate one steel coup with water, what reaction create
how to size H.T & L.T Panel ?
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
why i can not use thimble on capacitor duty contactor
specific difference of ICT&Auto Transformer
should %impedance be high or low in a power transformer? if so why?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
