what is the diffrence between mmwc and kg/cm2 for pressure
measurment when we are using mmwc and when kg/cm2 and why?????
?? what is the reason
- 19 Answers
- 195244 Views
- Ecoboard, Jindal, Sepco, I also Faced
- E-Mail Answers
Answer Posted / mail2noor.hyd
when we r measuring very low pressure :: mmWC
and measuring high pr. :: kg/cm2/bar/psi... ok
for example we r measuring like boiler furnaces
pressure(draft) i.e very low pr.(250mmWC) so we r measuring
in mmWC, and when we r calibrating the transmitters (flow
and level) that time also we r calling transmitters range
also mmWC ok
here note the point is 10,000 mmWC = 1 Kg/cm2 then
1mmwc=0.0001kg/cm2 ok
| Is This Answer Correct ? | 572 Yes | 56 No |
Post New Answer View All Answers
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
what is function of switch, and how is it work, explain with difination
How many ohms are required for proper earthing?
Explain pH, Conductivity.
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
What is the diffrence between ff tx and non ff tx
Identification of ss fittings, pilot valves, relief valve.
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
what are procedure of sox-nox calibration
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
please send data bank of quetions answers on analytical instrumentation.
How would you choose differential range?
