Interested to Buy Any Domain ? << Click Here >> for more details...
What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 30180 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / manoj patel
It is called as current transformer which is used to
transform higher range of current to lower range. It's
output is used as an input to protection circuit and
mearsuring instruments as the protection circuit and
measuring instruments are designed for lower range of
currents.
Care taken....If ther is metering core then all metering
instrument must be connected in series of S1 & S2
terminal.Same for protection core.
If there is single core CT then whenever its secondery is
not in used it should be shorted.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is pd controller?
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Why we use ups battery and dsdb battery in thermal power plant
is there any role of power factor with frequency variation? and how we can manage the frequency variation?
Explain the purpose of inductor in an electric circuit?
How is the percentage impedence of a transformer fixed at design stage???
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
Define non-touching loop.
Define characteristics impedance?
which metal is use in shunt
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
How do I calculate/select Droop CT ratio for various capacity of generators?
How will you utilise electrical power? You can start from the generating station.
