Answer Posted / maharaja.a
THE SENDING END VOLTAGE IS LESSER THAN RECEVING END VOLTAGE
Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What is the type of earth fault protection used in battery? explain.
Explain what is use of lockout relay in ht voltage?
1 hp is equal to how much watt?
how we can explain arc heatng?
how to enter inverter parameter? without manaual?
what is the difference between ac motor and dc generator
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
What is marx circuit?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
difference between high and low impedance BUS BAR relay??
full form of electrical?