If i switch on a transformer but with no load connected to
the secondary path.Is the transformer will burn?
Answer Posted / sree
No Load connected in the sence it is power
transformer.power transformer will not burn becuase the EMF
produced in secondary is a rated EMF.
Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
what is the VA(Volt-amphere)? define with calculation?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
what is meant by neutral compensation factor and where it is used
What is relation between mu(nought) and epsilon(nought)?
how to convert lv line to hv line and viseversa, any losses will occur during this process
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
Why the field rheostat is adjusted such that the voltmeter reads 380V
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
What is the technical difference between On delay timer and a Star delta timer?
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
what is the difference between ac motor and dc generator
diff. between tension mode & speed mode
What are the parts in a inverter?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?