the distance from my office to d.g is aprox 400mtrs and
voltage drops ibn my office near about 40 volt what should
i do p[ls suggest.
- 6 Answers
- 5318 Views
- I also Faced
- E-Mail Answers
Answer Posted / m.p.rajan
Friend
You can either shift ur DG near to ur office, or u change
the size of the cable connecting from DG terminal to switch
board, preferably with a copper cable. Present cable size
is very low compared to the distance and the load taken by
the cable, and hence u have a voltage drop of 40V.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to build a network which step down 415v to 1v rms
Define active and passive network?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
What are the conditions to be satisfied for parallel operation of dc generators?
What is acsr cable and where we use it?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
List out the the types of Mounting Light fixture?
what is the difference between oil surge relay and buchholz relay.
why swinburnes test cannot be performed on series machines?explain
How to test IR testing & magnetic balance test
Draw the single line diagram of the power station?
