Interested to Buy Any Domain ? << Click Here >> for more details...
What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 30234 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / iamsazz
It is current transformer. It mainly gives low amper in O/P
with respect to I/P. Output is in proportional to Input. By
this can measure high current flowing in line (say 10,000
A) using CT. The secondary should always be shorted for
protection before connecting to circuit unless it will
burst and caught fire.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
can we use NPT glands in LT panel
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
Define cuttoff frequency?
What is deference between MCB & MCCB & ISOLATOR
Explain how you decide what size of electrical wire do you need?
What are the different types of controllers?
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
Why PS class CT is always preferred for Differential protection?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What current flows in the transformer primary when its secondary is open?
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
What is the ratio of true power to apparent power in an ac circuit?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
