Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajiv mehta
To check whether the instrument in use is with in the
standard parameters
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How many ohms are required for proper earthing?
key phaser where is use and work
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
How d.p. Transmitter can be applied to close tank?
Why do we floating DC in DC system.
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
How does temperature bath work? How does coil gets heated only by applying some current?
