Interested to Buy Any Domain ? << Click Here >> for more details...
why we are used D.c. voltage in L.T.side or controling
side.we can use UPS also ,in place d.c. voltage
- 5 Answers
- 9129 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / dinesh kumar sharma
dc voltage is necessary for l.t pannels was because dc is
free from harmonics as well as smooth, in dc voltage no
variations are there so controlling becomes easier.
no we can not use ups takes ac to charge battery store in
dc and than when ever supply cut off than battery going to
discharge voltage is converted into dc to ac one of the
example in case of computer
and also ups can be used for smaller duration so why we
use UPS
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
along with technical test papers
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
How can we measure the residual voltage in dc machines?
why effective resistance should be more than static resistance in transmission line?
Explain Circuit Breaker Trip Characteristics in detail.
why ss stablity limit is more transient stablity limit?
How phase to phase voltage comes 440V.
what shoud be strength and weakness to impress interviewer????????
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
What is a parabolic signal?
A cotter joint is generally used to transmit
What is the ideal position cooling fan inside the dc motor?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
