Why 24VDC power Supply is used as standard for all loop
powered transmitters?
Answer Posted / maddy2504
It totally depends, 24 V DC 2 wire is not always applicable
every wehere some times it is 2 wire, 3 wire (2 cable for
power up & signal & 1 cable is for earthing), some times it
will 4 wire(2 for powerup & 2 for signal).
24 V Dc is for certain limit b'coz voltage will be drop in
that case w'll use 230v AC.
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
How to calibrate smoke Dectector
What is the minimum rating availalbe for weld neck orifice in market?
please send me the inteview questions in IOCL
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
What is zone,loop/fire alarm system?
what is the responsibility of an instrument commissioning supervisor
Define cryogenic?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
How to calibrate the flow transmitter
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
what is the protection system in solar turbine compressor