Interested to Buy Any Domain ? << Click Here >> for more details...
How to identify Motor leads in their order coming out from
winding without tag (U1, V1, W1 & U2, V2, W2)?
- 6 Answers
- 51541 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / s.gnanaprakasam
Take the megger,connect its one lead to any one of the
outcoming winding point.Rotate the megger operating handle
and simultaniously touch the other lead of the megger to
other{balance 5 winding points will be there} winding point
one by one.To which point,the megger is showing short
[reading 0] that is two ends of one winding.just assume,it
is U1,U2.Repeat the procedure for the remaining 4winding
points and mark it respectively V1,V2 &W1,W2.Also by using
multimeter in contunity mode with above said procedure ,we
can mark wdg. leads.
| Is This Answer Correct ? | 5 Yes | 51 No |
Post New Answer View All Answers
what may the reason for vector shift in a generator?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
What is difference between YNyn0 and YNyn ??
how flow current in 220 kv line to line
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
3phase cable calculation formula by motor load
What is mason's gain formula?
is it possible to test of bus bar in high rise building without completed full floor ?
What are the types of transformers according to the arrangement of iron cores?
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
in my working site. momentary jerck in electrical supply ocurred frequently which cause of multiple losses in our electrical equipements. how can we protect our electrical machines and equipements in this situation.
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
