Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between OP AMP and differential amplifier?
- 5 Answers
- 19047 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / sahil
Diff-amp is basically designed as DC-amplifier so that it
will be suitable for IC fabrication .Also the lower
frequency response is also improved.Taking i/p as
difference of 2signals is required so as to eliminate noise.
Diff amp is one of the stages of the Op-amp.Op-amp is
having very high gain which is obtained by using diffamp
transistors as darlington pair and their gain beta is
increased by punch through effect.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
How to Calibrate Coriolis Flow transmitter in field
what is sil (safety integrity level
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
key phaser where is use and work
Describe how to use megger to measure the earth resistance and insulation resistance
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
why we are not using the turbine flow meter in the steam service?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
