what is the potential difference between line and earth?
Answer Posted / prashant singh
tha potential of earth is 0 volt. When we measure the
potential between them then the maximum line voltage is the
maximum potential between them.
| Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
what is PID control in VFD drives?
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what are the interview question asked in wind mill about electrical
DEAR SIR,I GOT THE CALL LETTER FROM RRB, SECUNDERABD AS A JE-II SO PLEASE PROVIDE ME SOME MODEL QUESTION AND ANSWER PAPERS AND LAST YEAR QUESTION PAPERS
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
What is the formula to calculate the rating of a three phase miniature circuit breaker
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.