Interested to Buy Any Domain ? << Click Here >> for more details...
The cable area of cross section is 185 sq mm. How to convert this to the diameter.
- 7 Answers
- 16413 Views
- Syscon, I also Faced
- E-Mail Answers
Answer Posted / jyotirmaya
The simple formula is used same as the formula used to
calculate the diameter of circle from its given area. The
formula is as follows;
Diemeter = Over Root( Area x 4 x 7)/22
Diameter = Over Root (185 x 4 x 7)/22
= 15.34mm
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
how many electricity poles are there and what are the names and their sizes.
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
how to increase senstivity of ct
Name two low frequency oscillators?
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
Why star delta starter is preferred with induction motor?
What are the advantages of a three-phase system over a single-phase system?
How to select HT/MV cable size ?
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
for what purpose the star point is done in ct
what is the necessity of under ground cables ??
