Interested to Buy Any Domain ? << Click Here >> for more details...
during parallel operation of two ac generator which
condition must match before taking both parallel i.e
speed /voltage rating /kva/exciation
- 2 Answers
- 9547 Views
- I also Faced
- E-Mail Answers
Answer Posted / kamlesh g patel
incoming machine voltage should match the system/other
generator voltage.
frequency must be the same.
phase sequence must be the same.
| Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
how we sesign the transformer give some specifion regarding design of transformers
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
Draw the equivalent circuit of crystal oscillator?
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
If short circuit ratio is high is it bad or good for a machine then tell the reason...
in shunt clippers why a resistor is used in sereis with the input
what is PID control in VFD drives?
what is meant by brushed alternator & its working principle ?
USE OF 8 WAY PAN ASSEMBLY
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
33kv Rated output avilable in market (any where in india)
Do you know what is dry-out test in x'mer
