the distance from my office to d.g is aprox 400mtrs and
voltage drops ibn my office near about 40 volt what should
i do p[ls suggest.
- 6 Answers
- 5317 Views
- I also Faced
- E-Mail Answers
Answer Posted / sree
Add capacitors in load side, which improves your PF as well
as voltage.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
what does a k rating in a transformer means?
What is precision of a measurement?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
Why are lt windings placed near the core?
Inverter. converter. Ups.MCB.solar.alternators. motors.
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
Comment on the working principle of operation of a single-phase transformer.
How to set the relay,,??
Explain advantages of storage batteries
can i connect the two phases of scott connected transformer,if not why?
hello! sir i did three year of diploma in electrical (2007- 2010) and now i m a student of electrical engineering. sir can i apply for germany visa for study and part tome work over there?
how can i reduce sparking without stepdowning the voltage
what do you mean by class PS CT and what are technical details needed for calculating it?
