Answer Posted / giridharan
i would like to add up the measured value with true value
Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
how do u calibrate the vacuum transmitter if it shows more reading
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
what is the difference between -24 : +24 & 0:24 and where it use?
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Make Heater Process Logic.
How d.p. Transmitter can be applied to close tank?
what is sliding spool valves?
what is metal of piston ring
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
How to decrease opening & closing time of on/off valve?