hi... i am usin packet tracer 5.0.. i hav connect two
routers A and B. A has 200.100.25.100 and 1.0.0.1 and router
B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1
and 1.0.0.2... now i want to route 200.100.25.100 and
200.10.50.100 usin rip.. i enable rip in both the routers...
but whn i give the command show ip route... i jus get this
Codes: C - connected, S - static, I - IGRP, R - RIP, M -
mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA
- OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF
NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF
external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 -
IS-IS level-2, ia - IS-IS inter area * - candidate default,
U - per-user static route, o - ODR P - periodic downloaded
static route Gateway of last resort is not set A# so can
sombody tell me where i hav gone wrong...
thanku
Answer Posted / anju
ok ok... i solved it... i cudnt do it coz i din set the clock rate... :)... a silly mistake but its important... :)... thanku all
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Tell me which protocol called rapid protocol?
What do you mean by Port Mirroring?
Explain how an spf algorithm works?
Which command we give for live view of remote site routers?
What are the possible ways of data exchange in ccna?
Explain what is 5-4-3 rule?
How many hop counts are by default and how much you can increase in eigrp protocol?
what does PPTP use for encryption and authentication?
What is EIGRP?
Which cable called v.35?
Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)
what is prefix list
Why is network segmentation a good idea when managing a large network?
On which mode we give debug command?
Explain how many types of router?