Interested to Buy Any Domain ? << Click Here >> for more details...
what do we mean by hook up drawing. what r the information we
get from it?
- 7 Answers
- 34779 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / jaysoon
hook up drawing is refrence or information engineering
installation also specification the equipment to be install.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
any body please send me the old question papers of ongc test.
what is SIL 1 2 3
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
What is shielding effect?
What is furnace draft control?
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
what is the process to make control schematic ?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
What is the use of each wire in three wire RTD
