Interested to Buy Any Domain ? << Click Here >> for more details...
WHY DISEL GENRATOR SET SHUT DOWN IN OVER LOAD CONDITIONS
- 5 Answers
- 10440 Views
- HMT, I also Faced
- E-Mail Answers
Answer Posted / deltawye
the diesel generator set will shutdown during overload is
because of its voltage regulator
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
How is the gain affected by the introduction of feedback in a control system.
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
How to calculate the Efficiency of Chiller
What was your role in the silicon evaluation/product ramp? What tools did you use?
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
Why the efficiency of generator is more than motor in swinburne's test
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
While testing a ZCT what parameters have to check or measure?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
What is meaning of out of phase (making & breaking) capacity And how to calculate
why 1.7Uo for HV cable Hi pot test?IE standard why?
