Shall we get electrical shock if we touch the positive
terminal of a 230 volt dc supply?
Answer Posted / ajay
are puchane ki kya jarurat hai jao aur touch kake dekhle
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
two way ckt diagram can be drawn by how many ways? give diagram
i want to model paper for section engg.
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
How harmonic block test are conducted on relays ( Siemens,Areva ect )power transformer using omicron kit?
What is Servo Ventilated Motor?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
what is the ms flat constant for calculating earth mat design calculation?
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Which Class insulation is prefered for the sandwich Busducts ? Why?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
What is referred to the electron in the outer orbit?
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?