HOW WOULD YOU PRESENT THE POWER FACTOR PRACTICALLY ON A
GRAPH
- 4 Answers
- 9189 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / satya
power factor is the ratio of p and vi so we can take the
gralph between p and vi and slope of that gives us p.f
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
What are the Full Forms of TVM, MTL, CVT ?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
What happened when capacitor connect series in ac circuit?
i have a 1500kVA transformer what is the kWH meter i need to use?
How phase to phase voltage comes 440V.
How LT megger works ?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
Electrical Engineering
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
what happen when power factor of 2 parallely operated transformer become equle?
size of condotory fron voltage level
What is called limb of a transformer?
The principle of switching circuits for different types of batteries in application of storage systems
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
