Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / thowsif_emerosn
AMF panel and generator packages are designed to provide
emergency power during a mains supply failure.
During operation, the control panel of the AMF monitors the
mains entering the building. If a mains failure occurs, the
panel will disconnect the mains from the load, the
generator is started and its output connected to the load.
(The load being appliances, lights, etc in use within the
house/office/factory at the time of mains failure).
The generator continues to supply the building until the
mains supply returns.
The generator then automatically disconnects, stops and the
mains is re-connected to the load.
The AMF panel reverts to the standby mode ready to respond
in the event of another mains failure.
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
what is the question paper model for section engineer in RRB
Motor,transformers,capacitor tubelight etc....
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what is load vs Torque curve & why it is used?
How much dc volt applied in cathodic protection system?
What are the different methodes for calculating the short circuit Current?
Atwhat condition reverse power relay will act?
describe the phenomena of vacuum interruption in C.B
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
why does make gain margin and phase margin on same plot.?
Which test will be more severe for VCB?
i want to model paper for section engg.
