Answer Posted / வி
The procedure laid down or checking the absolute values on a measuring instruments is called Calibration .
"திருவையாறு" -
விக்னேஷ் குமார்
Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
What is the start up procedure of desalter
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
how do calibrate the valves.. with clear manual
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Explain the combusion chamber
How to calibration coriolis flow meter?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Differentiate between ultrasonic flowmeter and radar type flow meter
What is stripper & spilitter ? Diffrence in this.?
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
what is the reason while warning lamp is on while the engine is cranking?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
Using your own examples solve a problem involving normal table. (experimental method and analysis)