Interested to Buy Any Domain ? << Click Here >> for more details...
According to general circuit diagram of 1-Phase t/f , why
the primary is not get short circuited ,even though the
supply terminals both are directly connected through
primary winding?
- 4 Answers
- 5838 Views
- I also Faced
- E-Mail Answers
Answer Posted / t0cableguy
Magnetic induction is the way a transformer works, in all
reality it works somewhat like a motor to produce the
voltages. Ex. (step down transformer) The windings twist
around each other producing a 1:60 voltage drop.. meaning
for every 1 high voltage winding there are 60 low voltage
windings. the high and low voltage windings are isolated
from each other therefore a magnetic field is produced (the
product). That is your load for whichever voltage is feeding
the transformer , and the "source" side of the transformer
works SOMEWHAT like a magnetic induction motor at that point
and becomes your "source" of low voltage.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is diversity factor in electric installations?
What type of core material is used for metering C.T and protection C.T???
how much allowable resistance that can be difference in motor all coils?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
How can we findout the maximum efficiancy of Transformer? At which load?
Write the programming software name for LG, SIEMENS,Messung,AB
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
what is meant by re-rolling motor? how it differs from standard motor?
Why do not we prefer non conventional sources of energy to conventional sources?
can we conduct the swineburne's test on a dc series motor? why?
how to calculate vfd o/p voltage by frequency
