Interested to Buy Any Domain ? << Click Here >> for more details...
How to calibrate the magnetic flow meter and how to correct
the flow if it is showing more flow.
- 5 Answers
- 27980 Views
- Bohra Industries Limited, TCL, I also Faced
- E-Mail Answers
Answer Posted / maneesh
if the instrument is online calibration can be done by
closing the valve at downstream side.now the meter should
read zero if not recalibrate it.always remember while
calibrating magnetic flow mwter the meter should be filled
with fluid and fluid should be condectieve
| Is This Answer Correct ? | 21 Yes | 4 No |
Post New Answer View All Answers
please tel me the calibration of pneumatic controler.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
give some question relative instrument fitter?
Please any one can provide latest aptitude test,technical test and interview questions for tata consulting engineering (TCE) i need it asap thanks in advance
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
What are different types of orifice plates?
How will you calibrate PID controller? explain with example.
key exchanges in wpa,wpa2,tls
Which products are available in the Mass Systemswitch and System Manager AC range?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
