For testing 33kv cable hipot testing. How much kv we have to
Apply .Give in details.
- 23 Answers
- 93555 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.shiva krishna
AC Hipot test voltage = Nominal input voltage * 2 + 1000
DC Hipot test voltage = AC Hipot test voltage * 1.414
for 33kv
ac hipot v/g = 33000*2+1000 = 67kv
dc hipot v/g = 67000 * 1.414 = 95kv
| Is This Answer Correct ? | 16 Yes | 25 No |
Post New Answer View All Answers
how to ctrl motor by use of ac or dc drive.plz explain evdintly
What is mean by spike arrester(Voltage Operated)
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
Why use in ht motore
whether fibre optic cable in high voltage earth conductor is used for protection circuits
If any cable burnt how can we identify it burnt by high current of high voltage?
What is the difference between indoor and outdoor transformer
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
what is Fault level? why it is calculated? how will u decide same for our plant?
What cmos is and its benefits?
why star point of HT motor not earthed?
Is there any question in the name of Static Switch in UPS??
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
