hi this is noor in my work spot, i arranged THERMOCOUPLE in
the place of RTD. (in FEED WATER tank). can i use T/C or not?
- 10 Answers
- 9834 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish tyagi
No T/C are not suitable replaced for RTD because feed water
tank temperature below 120 Deg C (max.).T/C are right used
above 300 Deg C
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
what is the procedure of O2 sensor(ABB) calibration?
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
How d.p. Transmitter can be applied to open tank?
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
How can a d.p. Transmitter be calibrated?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
Explain about the leakage class of the control valves
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
What is three element drum level control system why its better than single element?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what is the input of digital counter during the the calibration time?
