Do you know how to joint the H.T and L.T Cables?
- 23 Answers
- 57126 Views
- KESC, MGVCL, Nokia, Oil Country Tubular, Power Control, SAGT, Siemens, Simco, Vivek Engineers, I also Faced
- E-Mail Answers
Answer Posted / rajendra
to joint these cableslike L.T. & H.T. cables there are many
componyes are providing the jointing kit for low tansion
cable in that kit some insulating material,lugs,earthing
wire, past to fill in joint are avable and instrction
manual also avable with kit. so we must read the jointing
procidure in the instruction manual & use this material to
joint the cable.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
difference between semiconductor & conductor & insulator?
How much load can take a 16 mm aluminum cable 3 phase
Is vtg is controlled by the resistor? if else how much?
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
Why we use circular(Stepped) cross section in transformer core?
whit is 33kv power 300*300 cable full current with formula
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
The loads are connected with phase and ground then why current flow as the loads ?
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
