Answer Posted / suthan prabhu
for copper cable 1Sqmm can carry 1.92 Amps .
Is This Answer Correct ? | 18 Yes | 32 No |
Post New Answer View All Answers
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
What is line resistance of cable & how it can be measured ?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
how many parameters can integrate with fire alarm basically ?
how mass curve differs from hydrograph.
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
when elecromagnatic waves are propogated in a wave guide?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
what is the difference between electrical and electronic choke?
what is ps impedance test
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
why we testing the core balance of the transformer before comissioning?