Answer Posted / mahder
No is normally open contact, that means at normal condition
it's open and the after getting energy or after being
energized it will change to closed or it will close it's
normally open contacts.
Nc is normally close contact, Nc have the reverse function
of No, at normal condition it contacts are closed and when
it gets energy(power) it will open it's contacts.
Is This Answer Correct ? | 21 Yes | 1 No |
Post New Answer View All Answers
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is
why need to be maintain power factor for industrial customer?
High speed earth switch operation with diagram
how many Classification of fire extinguisher
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
How many types of probe used in cro?
What is your acheivements
Power Factor Correction Panel (Manual & Automatic)
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0