Interested to Buy Any Domain ? << Click Here >> for more details...
tell me about the instrumentation,what is the actual need
of it ?what are the characteristics of a IC engineer ?
- 11 Answers
- 16840 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / ruban
instrumentation is the field which is used to study about
measurement and control process of equipment lik, plc,scada
and strain guage also it will go thrw thr process of
flow,pressure and temperature of the particular
innstruments which we r going to deal with this.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to Calibrate Ultrasonic Level Transmitter in field
if in a level tx height is given, how u calculate the ranges of the tx?
What are different types of valves?
What is zone,loop/fire alarm system?
Why we are using reverse action in displacer types level transmitters on some Vessels?
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
Explain pH, Conductivity.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
KAlman filter code for two dimension?
how can use ram
why we are using magnet for calibration of gas detector?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
how the arrangement of equipments done in control room
how many types of spped sensors n vibration sensors?their basic principle n connection?
