Interested to Buy Any Domain ? << Click Here >> for more details...
Hi, All
I am configuring EIGRP in Packet tracer, after configuring
all the things it is not working but in one condition it is
working fine if i am putting all my router and network
withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but
whenever i am puting different network subnets e.g. in one
network it is RA(config-if)#=ip address 10.0.0.1, and in
fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and
in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in
third router RC(config-if)#=ip address 11.0.0.2 and in fa
0/0 172.16.1.10 and after configuring all this serial is
showing up and protocol showing up but eigrp process not
taking place after adding eigrp configuration, i tried with
"no auto-summary" command but not working.. Suggest me where
i missing something? can mail me at : gtech.innovator@gmail.com
- 20 Answers
- 27516 Views
- I also Faced
- E-Mail Answers
Answer Posted / gt
Oh yes ..!! its seems like that you and Shahin talk and
share lots of information overhere and i would like to join
you guys.. so can we friend? :) ...
Actually i was quite surprise why my configuration is not
working on packet tracer coz previously i have done this
with lil bit bigger topology and it worked well.. i did
eigrp & ospf both on the same time.
Well keep mailing and share your precious knowledge..
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Which dynamic type draw back is, if single link down, it removes its routing table?
What is difference between tcp/ip and osi model?
Explian what is a node?
What is collision?
How does Hold-downs work?
What is osi reference model?
What is the beaconing?
Define routing?
what are the different symmetric algorithms?
How many fillers we can put in one ip of ipv6?
Which mode called privilege mode?
What is network?
What do we check while configuring the server?
Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?
How much hold down time of eigrep protocol?
