Hi, All
I am configuring EIGRP in Packet tracer, after configuring
all the things it is not working but in one condition it is
working fine if i am putting all my router and network
withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but
whenever i am puting different network subnets e.g. in one
network it is RA(config-if)#=ip address 10.0.0.1, and in
fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and
in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in
third router RC(config-if)#=ip address 11.0.0.2 and in fa
0/0 172.16.1.10 and after configuring all this serial is
showing up and protocol showing up but eigrp process not
taking place after adding eigrp configuration, i tried with
"no auto-summary" command but not working.. Suggest me where
i missing something? can mail me at : gtech.innovator@gmail.com
Answer Posted / gt
hahahahah...hahahahah...
I already did my searching on google and i got some IOS but
all these were corroupted or damaged, and also I dont have 1
GB RAM ... well but packet tracer is quite enough for ccna's
and if i got GNS3 wud be great for me to do some complicated
routing...
Thanx Shahin for you suggestion..will contact you again...
*GT#real name
*GT(real-n)# Gopalji Gupta
Take care..
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is EIGRP?
How many hope count rip or rip2 can send updates?
1900 Value in which type of access list?
Can you explain VPN tunneled packet in detail?
What is the mau?
Which cable called roll-over?
What is the checksum?
What is the difference among straight cable, cross cable and rollover cable?
Define class full protocol?
which points are eliminated by the DBSCAN algorithm?
Define topology?
What is the point-to-point protocol in ccna?
Mention what is the difference between the switch, hub, and router?
What is the easiest way to remotely configure a router?
Mention the ranges for the private IP?