Interested to Buy Any Domain ? << Click Here >> for more details...
Hi, All
I am configuring EIGRP in Packet tracer, after configuring
all the things it is not working but in one condition it is
working fine if i am putting all my router and network
withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but
whenever i am puting different network subnets e.g. in one
network it is RA(config-if)#=ip address 10.0.0.1, and in
fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and
in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in
third router RC(config-if)#=ip address 11.0.0.2 and in fa
0/0 172.16.1.10 and after configuring all this serial is
showing up and protocol showing up but eigrp process not
taking place after adding eigrp configuration, i tried with
"no auto-summary" command but not working.. Suggest me where
i missing something? can mail me at : gtech.innovator@gmail.com
- 20 Answers
- 27771 Views
- I also Faced
- E-Mail Answers
Answer Posted / gt
lolzzzz... yes your are right Ricky , Its funny even i tried
with some other dynamic protocols like OSPF, but the problem
is same.
well thank you all for giving your view & support.
Have Great Day..!!
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
When written
What is the command for change serial cost?
What requirements should a VPN fulfill?
What is the minimum and maximum request timer?
Explain the difference between arp and rarp?
On which interface we always apply access-list?
Which classes are assignable?
What route entry will be assigned to dead or invalid route in case of RIP?
What is ccna?
What is 10base2 ethernet lans?
What is the difference between full duplex and half duplex?
If there is only 2 host in bus topology is that possible collision accord?
Which protocol you manually enable route summarization?
What is DHCP stand for?
What is a digital certificate?
