why we generally use 3.5 core cable or in other word 1/2
core for neutral and also confirm me that in balance
conditiob(3 phase)current in neutral will zero
Answer Posted / mritunjay singh yadav
for using 3-phase supply in any instrument neutral is also
required since neutral capacity is just half to the phases.
we dont need to use 4 core thats cost matter..
| Is This Answer Correct ? | 0 Yes | 24 No |
Post New Answer View All Answers
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
what is buffer resistance starter.?.What is the working principle and where it is used..?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
I am an American living in Vietnam and I have recently gotten a refrigerator from Japan and it is rated for 100 vac, but the power here is 220 so I bought a voltage stabilizer it has a 1 kva output rating. Can you please tell me what the amperage is? I'm confused and without a working fridge.
11000volt DG set carnt kaise banvay
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
what will happen if ac and dc supplies given
What is the difference between Static and servo controlled voltage stablizer?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
how to remover corona effect and hysteresis losses from contactor
how we can set the IDMT relay.
Why are lt windings placed near the core?
what is PDU in transformer?? which company manufacture??