Interested to Buy Any Domain ? << Click Here >> for more details...
what is the similarity and difference between ups and
inverter?
- 4 Answers
- 15544 Views
- GMR, I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson_csm team
A UPS consist of 3 parts ,inverter ,charger,and AVR
(voltage regulator).when mains is present a UPS provides
supply to computer in regulated mode using inbuilt AVR ,and
simultaneously charges the batteries.
when mains fails it changes over to inverter mode using an
electromechanical relay (The changeover time is as fast as
4 milli secs in offline UPS).The charging current of ups is
normally 1amps to max 6 amps
in case of inverter when mains is present it bypasses what
ever comes in betweeen 100-280 volt(a typical setting in
all reputed brands)
when mains fails it changes over to inverter mode and
change over time as high as 200 mill secs.
The charging current is high minimum 8 amps and can go upto
20 amps
there are some companies which make special kind of
inverter under the name of home ups.These are ordinary
inverter with two difference ,one----the change over is
made very fast upto 10 millisecs,
second input mains range is reduced to 190-250 v A/C,so
that if it goes below 190 volts it goes to batt mode and
same is te case when input exceeds 250.These kind of home
UPS are succes ful only upto one PC ,with higher number of
PCs the complaint of rebooting whem mains fails increases
drastically,hence never recommended.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
how much GROUND & NEUTRAL VOLT maintain in data center.
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
What is the meaning of C1, C61, C91 cable
What is the phase relationship between the primary and secondary voltages of a transformer?
how to commissioning the genset with amf panel?
why effective resistance should be more than static resistance in transmission line?
Draw the single line diagram of the power station?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
is ac supply can store
Readings of ER300P Trivector meter
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
Explain using drawings what is reverse PID action w.r.t PID controllers.
What is an 86-P or an 86-A trip
why would amp draw on neutral wire be as much as amp draw on the hot leg.
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
