Interested to Buy Any Domain ? << Click Here >> for more details...
We have 3 Gensets 1.500kva,2.380kva,3.250kva How can we
connect in common busbar&we have variable load.
- 4 Answers
- 7450 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishvesh
yes, we can connect this three generators in one busbar,
after fulflling following conditions.
1.voltage should be same.
2.frequency should be same.
3.phase sequence should be same.
after shynchronizing of all three outputs, we can
connect it to the common busbas.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
Where can i get practical knowledge of solar system?
why -48 volts dc used in telecommucation
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
i have a 1500kVA transformer what is the kWH meter i need to use?
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
what is the Pickup/drop off ratio in BCPU relays
in india per day how much power is generated including all power station
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
how to select proper cable for ct wiring so that drop within the limit.
