What is C.T, why it is used and what care should be taken
for that while connecting?
Answer Posted / vishvesh
normally in high voltage line is it not possible to measure
current directly by any instrument for measuring of
protection purpose. CT (current transformer) as the name
suggest step down the value of current to very nominal
stage so that normal instrument can get reading from it.
and with progressive ratio calibration. we can get actual
value of current flowing through the line. also the relays
for the protection are connected with secondary of CT.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the specifications for conducting earth leakage test as per IEC standard?
How could a garment factory benefit from renewable energy
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
What is the drawback of static coefficients?
What is the type of feedback used in an op- amp schmitt trigger?
HOW TO TEST A LIGHTENING ARREST ER ?
i wasted one year for the job after completed my btech what can i say about 1year time in interview
Why is better to have a minimum ceiling voltage of 250% than 160%?
what is Different between Bilinear and Unilenier?
which protection function should measure RMS value of current&DFT value of current?
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
What is nichols chart?
what is 400kv doble circuit quadpole tower?