Answer Posted / thowsif_emerson_csm team
APFC Panels:-
An automatic power factor correction unit is
used to improve power factor. A power factor correction
unit usually consists of a number of capacitors that are
switched by means of contactors. These contactors are
controlled by a regulator that measures power factor in an
electrical network. To be able to measure power factor, the
regulator uses a current transformer to measure the current
in one phase.
Depending on the load and power factor of the network, the
power factor controller will switch the necessary blocks of
capacitors in steps to make sure the power factor stays
above a selected value (usually demanded by the energy
supplier), say 0.9.
Syncronous Condenser:-
Instead of using a set of switched
capacitors, an unloaded synchronous motor can supply
reactive power. The reactive power drawn by the synchronous
motor is a function of its field excitation. This is
referred to as a synchronous condenser. It is started and
connected to the electrical network. It operates at full
leading power factor and puts vars onto the network as
required to support a system’s voltage or to maintain the
system power factor at a specified level.
Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
what is earth resistance? how to measured? and give values at power station and mcc area?
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
how to calculate the Neutral transformer impedance?
How they LT panel busbar size choose
What is your acheivements
How to resolve if Diesel generator stop while running ?
is there any current and voltage drop on liquid resistance starter water/soda tank ?
why h parameter are called as hybrid parameter?
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
how we find transformer capacity by ohm
what is meant by directional earth fault and non directional earth fault? describe both.
concept of busbar and load dispatching..?
how to work droop ct in generating station
What is the ideal position cooling fan inside the dc motor?