Interested to Buy Any Domain ? << Click Here >> for more details...
ok this is practical senario question
how can we comunicate two diffrent network host by i single
1603 sires of cisco router rember that the cisco series of
that router have singe 100mbps ethernet
now think think
write all command
answer is so simple i wiil; give the answer after 20 visit
til then wait
- 2 Answers
- 5258 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera kuamr sinha
router(config)#interface e0
#ip address x.x.x.x y.y.y.y(NEtmask=Y)
#no shut
#exit
rouetr(config)#interface e0
#ip address a.a.a.a b.b.b.b secondry
#no shut
#exit
router(config)#now from here you can apply your route
according to your network scenario.
but not forget to advertise secondary ip address on the
routing table
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Mention what does data packets consist of?
After how long eigrp protocol advertise its routing table?
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
When we do default route?
What is the difference between tracert and traceroute?
What is protocol data unit in ccna?
What is the formula for metric of ospf?
What is the cladding?
Which mathematically form used inipv6?
which defined peer ip address an local subnet belong to crete? (Choose two)
Brielfly explain the conversion steps in data encapsulation
What does data packets consist of?
Explain the draw back of eigrp protocol?
Tell me how much internal and external ad of eigrp protocol?
What are the possible ways of data exchange in ccna?
