Answer Posted / amritpal singh sidhu
AVR:- Automatic Voltage Regulator.
Functions:-This AVR provides regulated voltage to the
exciter windig of the DG set. This AVR regulates the
voltage level as per requirement. In case the AVR has gone
faulty then to overcome the problem we can utilize the 12V
DC voltage from DG battery to take proper voltage with
normal load.
Is This Answer Correct ? | 43 Yes | 9 No |
Post New Answer View All Answers
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
What is the difference between diode and a transistor in terms of the direction of current flow?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
What conditions are required for transformer to operate at low frequencies ?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
How to calculate Air conditioning capacity for a telecom BTS shelter?
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
wish of these transformer uses oil?
How do we find the rating of a transformer, if it got burnt badly.
What is the function of NER and NET?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.