Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / venkatesan
1.insulation resistance test
2.ratio test
3.short circuit test
4.open circuit test
5.back to back test
6.oil testing
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
What are the advantages of nichols chart?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is a Phase shift meter? Where can I get one?
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
how to do the ductor test?
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
why only exciting current is shown not primary current in transformer???
Explain The Application Of Storage Batteries?
how calculate gd2 of ht motors
What is the effect of positive feedback on stability of the system?
Why transformer used in UPS??
WHat is the general checks required for Dry type transformers
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
what is the minimum winding resistance of 30hp compressor, to run or to switch on
