Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / laxminarayana
The powe which is in phase with current is called active
power and which is perpendicular to the current is called
reactive power
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
What is mason's gain formula?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is meant by brushed alternator & its working principle ?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
how do prepare ongc exam.how is it question model.i am electrical. which part covering in electrical.tell me
how to calculate
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
What is cross over distortion? How it can be eliminated?
State thevenintheorem?
what are symmetrical and non symmetrical components in electrical installation.
What it the purpose of parallel phasing transfomers??
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
