Interested to Buy Any Domain ? << Click Here >> for more details...
We have 3 Gensets 1.500kva,2.380kva,3.250kva How can we
connect in common busbar&we have variable load.
- 4 Answers
- 7253 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
we have to synchronise 3 dg for busbar connection.basic
conditions r
1.freq of all dg should be same.
2.phase seq shold be same.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
Draw transformer phasor diagram.(full load,no load)
Define the overload capacity of the motor?
Is it possible to measure the voltage of a battery from a single terminal?
What is meant by control system?
How can we findout the maximum efficiancy of Transformer? At which load?
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
Why delta star trformers are used for lighting loads?
What is the purpose of stablization resistor in high impedance bus bar protection
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
can anyone tell me can the electromagnetic waves can be reflected back?if so how &by which material it can be reflected back?please tell me so that it can help to my wireless power trasnmission device.
What is the basic principle of welding process?
What is lighting kitts.
