Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / paritosh shah.
Low and High Tension refers to the Voltage of the system.
Normally 1100 Volts (1.1 KV ) and above voltages are
considered H.T.
Voltages below 1100 Volts - e.g. 415, 660 etc. are
considered L.T.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
salam,hi, i need to know what the spesification of 300amp msb...
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
what is the practical application of full adder circuit?
How to distinguish whether MCB is DC or AC looking at it physically
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
What is the numerical quantity of sqcm?
How to know the Max. current caring capacity of the cable by its size ?
suri transmission
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
why on delay timer used for fully automatic star delta starter?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
How 3 phase invertor works?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
