Interested to Buy Any Domain ? << Click Here >> for more details...
after parallaing two generators current is shooting up in
both the generators.for ex: load is 400 kw..after paralling
and load sharing current in running gen is approx 900 amps
and incoming is 750 amps which is too high when trying
toshift the load current in incoming gen is coming more
than 1300 amps and both getting tripped and making
blackout..
- 3 Answers
- 5767 Views
- I also Faced
- E-Mail Answers
Answer Posted / raj
Is both generator parallel to GRID means Your generator
AVR is not working properly, these requrired kvar sharing
must is there available or not If availabel AVR settings to
shoule be change then is not solved the problem it is
required winding test required.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the advantages and disadvantages of closed-loop control system?
Can we use shunt trip coil instead of trip coil with protection relay for protection?
WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
What is the unit of magnetic flux density?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
why electronic instruments is more favorable than electrical?
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
Brief me about maintenance planning & sheduling of machine tool.
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
How to calculate earth wire load by formula
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
define hysteresis loss, eddy current loss and windage loss
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
Explain dc generator with its types?
