Interested to Buy Any Domain ? << Click Here >> for more details...
what is the relation between Sq mm of wire and its current
carrying capacity?
- 5 Answers
- 29777 Views
- Finolex, I also Faced
- E-Mail Answers
Answer Posted / jk
Standard quation R=1/a and I=1/R
a=cross sectional area in Sq.mm
R=Resistance in ohms
I=Current in Ampere
now if we shorting above two euation in one form the the
formula become I=a means current is directly proportional
to the cross-sectional area of cable.inshort if cross-
sectional area increase then the current carrying capacity
is also increase of the cable.
| Is This Answer Correct ? | 29 Yes | 7 No |
Post New Answer View All Answers
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
what is the principle of operation of CFL ??
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
specify the inbuilt protections in DG
Which type of DG need Netral Earthing?
how to decide no of electrodes for 1600A LT Main incomer panel
What is the purpose of stablization resistor in high impedance bus bar protection
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
CBCT selection
The series field winding has low resistance while the shunt field winding has high resistance. Why?
Can any body tell gulf interview question for experienced electrical engineer ?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
