how the lap length is calculated in reinforcement of 110mm
dia steel of Length 15.00 mtrs. & grade of concrete is M20
- 22 Answers
- 99675 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / vahab shaik
for the compression zone it is 55D & for tension zone it is
45D
i.e for 10mm Dia
Compression---55*10=550mm
Tension-------45*10=450mm
| Is This Answer Correct ? | 55 Yes | 54 No |
Post New Answer View All Answers
What Is the Thumb rule to calculate depth and dia of pile required to carry specified load on differeent soil
at which depth the construction of tunnel is economical from cost and engineering aspect.
construction workers how much time take one work or qty
How much cement and water required for cement selery????
On what basis we decide the formation level of the road? other then that of 50% Cutting and 50% Filling??
What is meaning of FREE STANDING STAIRCASE ?
I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????
how to calculate freeboard in under ground water tank and technical details
What is the coeffiencent Friction Angle between Steel and Ashphalt?
if the nitrates more than 45mg/l in water lead to disease then what is it called
door and window wood work calculations and different methods
What is a kip?
What is componsation
Can someone please be curing period of the following according to IS codes Column beam slab brick masonry raft found. and also tell how many hours/day
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
