Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prometheus
if we consider the construction of transformer there are two
type......as stated over.......shell type and core type. But
if we see it by its use...there are three types of
transformers....1)current transformers....2)Potential
transformers....3)Power transformers.....and if we see it by
its working principle, then there are two type of
transformers...1)step up....2)step down....there is another
type of transformer .....auto transformer
| Is This Answer Correct ? | 27 Yes | 0 No |
Post New Answer View All Answers
Explain what is electric traction? Explain few advantages of electric traction system?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
Can an inverter be used as a converter? How?
How i can decide that HVDC line is best for transmission.
why to use freewheeling diode ( diode in revers bias mode) across dc coil
Why do not we prefer non conventional sources of energy to conventional sources?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
what parameters should we check to reduce the power bill
any one can explain the stages of a knee point which is taken during ct magnetising curve.
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
How to perform a DC resistance test In Alternator and their proceduces?
